Setting Operation Mode
Before scanning, set the operation mode on the control panel to match the computer on which Document Capture
Pro is installed.
1. Select Settings from the home screen.
2. Select General Settings > Scan Settings > Document Capture Pro.
3.
Select the operation mode.
❏ Client Mode: Select this if Document Capture Pro is installed on Windows or Mac OS.
❏ Server Mode: Select this if Document Capture Pro is installed on a Windows Server. Next, enter the server
address.
4. If you have changed the operation mode, check that the settings are correct, and then select OK.
Scanning Using the Document Capture Pro Settings
Before scanning, prepare the followings.
❏ Install Document Capture Pro on your computer (server) and create the job.
❏ Connect the printer and the computer (server) to the network.
❏ Set the operation mode on the control panel.
1. Place the originals.
Note:
If you want to scan multiple originals or make 2-sided scans, place all of the originals in the ADF.
2. Select Scan on the home screen.
3. Select Document Capture Pro.
4.
Select Select Computer., and then select the computer on which you created the job in Document Capture
Pro.
Note:
❏ e printer's control panel displays up to 100 computers on which Document Capture Pro is installed.
❏ If you have selected Option > Network Scanning Settings, and enabled Protect with password in Document
Capture Pro or Document Capture, enter a password.
❏ If Server Mode is set as the operation mode, you do not need to perform this step.
5.
Select Select Job., and then select the job.
Note:
❏ If you have selected Protect with password in the settings in Document Capture Pro Server, enter a password.
❏ If you have set only one job, you do not need to select the job. Proceed to the next step.
6. Select the area in which the job content is displayed, and then check the job details.
7. Tap
x
.
User's Guide
Scanning
112
To Next Page
Loading...
Need help?
General
