Epson WorkForce 633 - Page 22

2011/03/02
Revision: 1 Page: 22
Table 5 Command Sequence for the newer Method of ESC ( D command method of graphics data transmission
Transfer cycle Details of setting Items set Commands used
By document
1. Initialize settings
Exit Packet Mode
Enter remote mode
Set Printer Timer**
Job Start
Set Job Name
Paper Feed Setup
Other Remote Commands
(optional)
Exit Remote Mode
1.2 Initialize printer
1.3 Select graphics mode
1.4 Set unit
ESC SOH @EJL…
ESC (R
TI
JS
JH
SN
ESC 00H 00H 00H
ESC @
ESC ( G
ESC ( U
2. Prin
ting method control
2.1 Turn unidirectional mode on/off
2.2 Select Monochrome or Color
2.3 Select Ink Drop Size
2.4 Set resolution of Raster mode
ESC U
ESC ( K
ESC ( e
ESC ( D
3. Set print format
(single sheet)
3.1 Set page format
3.2 Set paper dimension
3.3 Set print method ID
ESC ( c or ESC( C
ESC ( S
ESC (m
By page
By raster
4. Set vertical position
4.1 Set vertical print position
ESC ( V or ESC (v
5. Transfer data
5.1 Set horizontal print position
ESC(/ or ESC ($
5.2 Pri
nt raster graphics:
repeat above for each color
ESC
i
6. Form feed
6.1 Form feed
FF
7. Terminate printing
7.1 Initialize printer
7.2 Enter Remote Mode
Load NVR Settings
Job End
Exit Remote Mode
ESC @
ESC (R
LD
JE
ESC 00H 00H 00H
*In the case of micro weave print mode, ESC ACK command is inserted only when the plural passes are specified
with no paper feed.
** It is necessary to send the TI command before the JS command.