Epson WorkForce 633 - Job Name Set JH Nl Nh 00 H M1 M2 M3 M4 M5 <Job Name

2011/03/02
Revision: 1 Page: 67
6.1.6 Job name set “JH” nL nH 00H m1 m2 m3 m4 m5 <job name>
[Format]
“JH” nL nH 00H m1 m2 m3 m4 m5 <job name>
nL = (length of <job name) + 6
nH = 00H
[Parameters]
The parameter “m1” is one byte binary data that indicates types of job name information.
The parameters “m2”,”m3”,”m4”,”m5” are each one byte binary data that indicate Job ID.
“<job name>” is a maximum of 32 bytes of binary codes that describe a job name.
m1=00h;<job name>=Host name(Max 32byte)
m1=01h:<job name>=Product ID
m1=02h:<job name>=Document name
m1=03h:<job name>=User name
[Function]
Set the job name of the job specified by “JS” command.
This command will be ignored and skipped if the product does not support this command.
This command is available only in Remote.