Epson WorkForce 633 - Turn Printer State Reply On;Off (Remote Mode) ST 02 H 00 H 00 H M1

2011/03/02
Revision: 1 Page: 66
6.1.5 Turn printer state reply on/off (Remote Mode) “ST” 02H 00H 00H m1
[Format]
“ST” 02H 00H 00H m1
[Parameters]

Parameter m1 is a one byte binary parameter, and indicates the setting as follows:
m1 Printer State Reply
10H Binary state reply Off
11H Binary state reply On
[Function]
-The default environment status transmission is set. See the paragraph of status transmission for the status transmission.
-This setting depends on interfaces that receive this command. For example, this command is received with the built-in Macintosh
serial interface; the status transmission for the built-in Macintosh serial interface is set.
-If the parameter m1 is out of range, or if setting of parameter m1 is not supported by the product, this command is ignored, and the
existing setting is maintained.
-This command will be ignored if this command is not supported.
-This command is only available in Remote Mode.
Auto interface select function
-If the status transmission is ON, the interface transmits the status whether the interface is selected or the interface is deselected
by the auto interface select function.