Epson WorkForce 633 - Set Horizontal Print Position (Remote Mode) FP 03 H 00 H 00 H M1 M2

2011/03/02
Revision: 1 Page: 65
6.1.4 Set horizontal print position (Remote Mode) “FP” 03H 00H 00H m1 m2
[Format]
“FP” 03H 00H 00H m1 m2:
[Function]
* The parameter “m1” , “m2” are each one byte binary data that indicate the below condition
according to the following formula.
* The unit of print start position is 1/360 inch.
(print start position) = ( ( m2  256 ) + m1 )
Horizontal Print Start Position m1 m2
Standard position 00H 00H
Borderless print position B0H FFH
* If the parameter is out of range, this command is ignored, and the previous setting is
maintained.