Epson WorkForce 633 - Line Feed LF

2011/03/02
Revision: 1 Page: 28
5.1.3 Line feed LF
LF Ver. 1.00
[Name] Line feed [Operation]
[Format] 0AH
[Range of Definition] -
[Function] 1) Advances the current printing position in the positive Y direction by an amount equal to the
current line separation amount. Sets the printing position in the X direction to the starting
point (the left margin position) on the X axis of the position management coordinate
system.
2) If this command sets the Y direction printing position into the non-printable area, then the
page is ejected. The position management coordinate system is set to the next page. In
addition the printing position is set to the origin of the position management coordinate
system for the new page.
[Initial State] -
[Related Commands]
Related Command [Setting]s that apply an effect.
None
Related Command [Setting]s that receive an effect.
None
Related Command [Operation]s that apply an effect.
None
Related Commands [Operation]s that receive an effect.
The amount of advancement per line is set by the ESC + command.
The non-printable area is set by the ESC (c command.
The amount of advancement per line, the non-printable area, and the left margin position
are reset to their initial state by the ESC @ and ESC (G commands.