❏ When you print on envelopes, be sure to specify the envelope on the print driver. If not specified, the
print image will be rotated 180 degrees.
❏ If you do not load envelopes in the PSI right after they have been removed from the packaging, they
may bulge. To avoid jams, flatten them as shown below before loading them in the PSI.
❏ If envelopes are still not fed correctly, add some bending to the flap of the envelopes as shown in the
following illustration. The amount of the bending shall be 5 mm (0.20 inches) or less.
AL-M200 Series User’s Guide
Printing Basics 119
To Next Page
Loading...
