Problem Action
The printed result is foggy. When the whole is printed light, contact our local representative office or
authorized dealer.
When the printed page is partly light, start Clean Developer.
1. Launch the Printer Setting Utility, and click Clean Developer on the Diagnosis
tab.
2. Click the Start button.
Note:
If the problem continues even though you have taken suggested actions described above, contact our local
representative office or authorized dealer.
Bead-Carry-Out (BCO)
Problem Action
Bead-Carry-Out (BCO) is happening. If the printer is installed in a high altitude location, set the altitude of the location.
1. Launch the Printer Setting Utility, and click Adjust Altitude on the Printer
Maintenance tab.
2. Select the value close to the altitude of the location where the printer is installed.
3. Click the Apply New Settings button.
Note:
If the problem continues even though you have taken suggested actions described above, contact our local
representative office or authorized dealer.
AL-M200 Series User’s Guide
Troubleshooting 197
To Next Page
Loading...
