Epson WorkForce AL-M200DN - Disabling the Panel Lock Feature; Changing the Power Saver Mode Settings

Note:
❏ If you forget your password, turn off the printer. Then, while holding the
(Menu) button, turn on
the printer. Continue to hold the
(Menu) button until the LCD panel shows Ready to
Print.
❏ If you want to change the password while Panel Lock Set is Enable, perform steps 1 and 2. Enter
the current password, and then press the
button. Perform steps 3 and 4. Select Change
Password, and then press the
button. Enter a new password, and then press the button. This
will change the password.
Disabling the Panel Lock Feature
1. Press the (Menu) button.
2. Select Admin Menu, and then press the
button.
3. Enter the password, and then press the
button.
4. Select Secure Settings, and then press the
button.
5. Select Panel Lock, and then press the
button.
6. Select Panel Lock Set, and then press the
button.
7. Select Disable, and then press the
button.
Note:
The password is reset to 0000 when the setting for Panel Lock Set is changed from Enable to
Disable.
Changing the Power Saver Mode Settings
The printer enters a power saver mode after the specified time period of inactivity. You can set Power
Saving Timer to place the printer in either of the power saver modes.
1. Press the
(Menu) button.
2. Select Admin Menu, and then press the
button.
3. Select System Settings, and then press the
button.
AL-M200 Series User’s Guide
Using the Operator Panel Menus 172