6. Select the software to be installed, and then click Install.
7. Click Finish to exit this tool.
The wireless configuration is complete.
EpsonNet Config
1. Select EpsonNet Config, and then click Next.
2. Follow the on-screen instructions until the Check Setup screen appears.
3. Confirm there are no errors displayed on the LCD panel, and then click Start Installation.
If you see any errors, click Trouble Shooting Guide and follow the instruction.
4. Check if the printer to be installed is listed in the Select Printer screen, and then click Next.
Note:
If the printer to be installed is not listed in the Select Printer screen, try either of the following steps:
❏ Click Refresh to update the information.
❏ Click Add Printer, and then enter the details of the printer manually.
AL-M200 Series User’s Guide
Printer Connection and Software Installation 58
To Next Page
Loading...
