2. Select Admin Menu, and then press the button.
3. Select Network, and then press the
button.
4. Select Wi-Fi Setup, and then press the
button.
5. Select the desired access point, and then press the
button.
If the desired access point does not appear:
a Select Manual Setup, and then press the
button.
b Enter the SSID, and then press the
button.
Use the
or button to enter the desired value, and press the or button to move a
cursor.
c Select Ad-hoc, and then press the
button.
d Select an encryption type, and then press the
button.
Important:
Be sure to use one of the supported encryption methods to protect your network traffic.
6. Enter the WEP key, and then press the
button.
Use the
or button to enter the desired value, and press the or button to move a cursor.
7. Select a transmit key.
8. Wait a few minutes until the printer restarts to establish the wireless network.
9. Print a System Settings page from the operator panel.
See “Printing and Checking the System Settings Page” on page 34.
10. Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
Note:
When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
AL-M200 Series User’s Guide
Printer Connection and Software Installation 86
To Next Page
Loading...
