EasyManuals Logo

Epson WorkForce Pro WF-C4810 Series User Manual

Epson WorkForce Pro WF-C4810 Series
383 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #199 background imageLoading...
Page #199 background image
Error Messages Solutions
Recovery Mode
Update Firmware
The printer has started in recovery mode because the rmware update
failed. Follow the steps below to try to update the rmware again.
1. Connect the computer and the printer with a USB cable. (During
recovery mode, you cannot update the rmware over a network
connection.)
2. Visit your local Epson website for further instructions.
*In some print cycles a very small amount of surplus ink may be collected in the borderless printing ink pad. To
prevent ink leakage from the pad, the product is designed to stop borderless printing when the pad has reached its
limit. Whether and how oen this is required will vary according to the number of pages you print using the
borderless print option. e need for replacement of the pad does not mean that your printer has ceased to operate
in accordance with its specications. e printer will advise you when the pad requires replacing and this can only
be performed by an authorised Epson Service provider. e Epson warranty does not cover the cost of this
replacement.
Paper Gets Jammed
Check the error displayed on the control panel and follow the instructions to remove the jammed paper including
any torn pieces. e LCD screen displays an animation that shows you how to remove jammed paper. Next, select
OK to clear the error.
!
Caution:
Never touch the buttons on the control panel while your hand is inside the printer. If the printer starts operating, it
could cause an injury. Be careful not to touch the protruding parts to avoid injury.
c
Important:
Remove the jammed paper carefully. Removing the paper vigorously may cause damage to the printer.
Preventing Paper Jams
Check the following if paper jams occur frequently.
Place the printer on a
at
surface and operate in the recommended environmental conditions.
“Environmental
Specications
” on page 300
Use the paper supported by this printer.
“Available Paper and Capacities” on page 259
Follow paper handling precautions.
“Paper Handling Precautions” on page 27
Load paper in the correct direction, and slide the edge guide against the edge of the paper.
“Loading Paper” on page 29
Solving Problems
>
Paper Gets Jammed
>
Preventing Paper Jams
199

Table of Contents

Other manuals for Epson WorkForce Pro WF-C4810 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson WorkForce Pro WF-C4810 Series and is the answer not in the manual?

Epson WorkForce Pro WF-C4810 Series Specifications

General IconGeneral
ConnectivityUSB, Ethernet, Wi-Fi, Wi-Fi Direct
Automatic Document FeederYes
ADF Capacity35 sheets
Duplex PrintingYes
FunctionsPrint, Copy, Scan, Fax
Print Resolution4800 x 1200 dpi
Print Speed Black25 ppm
Print Speed Color20 ppm
Paper Capacity250 sheets
Display2.4" color touchscreen
Mobile PrintingApple AirPrint
Printer TypeAll-in-One
Paper SizesLetter, Legal, A4, A5, A6, B5, envelopes
Ink Cartridge Configuration4 individual ink cartridges
Print TechnologyPrecisionCore

Related product manuals