3.
Enter the time server address for Time Server Address.
You can use IPv4, IPv6 or FQDN format. Enter 252 characters or less. If you do not specify this, leave it blank.
4.
Enter Update Interval (min).
You can set up to 10,080 minutes by the minute.
5.
Click OK.
Note:
You can conrm the connection status with the time server on Time Server Status.
Setting the Default Value for Scanning,Copying and Sending Faxes. (User
Default Settings)
You can set the default value for the functions.
You can set the following functions.
❏ Scan to Network Folder/FTP
❏ Scan to Email
❏ Scan to Memory Device
❏ Scan to Cloud
❏ Copy
❏ Fax
1.
Access Web
Cong
and select the functions for which you want to set the default value for the Scan/Copy tab
> User Default Settings.
Select the Fax tab > User Default Settings to set the default value for fax.
2.
Set each item.
3.
Click OK.
If the combination of the value is invalid, it is automatically modied, and then a valid value is set.
Problems when Making Settings
Hints to Solving Problems
❏ Checking the error message
When trouble has occurred,
rst
check whether there are any messages on the printer's control panel or driver
screen. If you have the notication email set when the events occur, you can promptly learn the status.
❏ Network connection report
Diagnose the network and the printer status, and then print the result.
You c a n
nd
the diagnosed error from the printer side.
Administrator Information
>
Settings to Use the Printer
>
Problems when Making Settings
359
To Next Page
Loading...
Need help?
General
