1.
Place the
rst
batch of originals at the same size.
2.
Select Fax on the home screen.
3.
Specify the recipient.
4.
Select the Fax Settings tab, and then tap Continuous Scan(ADF) to set this to On.
You can also make settings such as the resolution and the sending method as necessary.
5.
Tap
x
(Send).
6.
When scanning the
rst
set of originals is complete and a message is displayed on the control panel asking you
to scan the next set of originals, set the next originals, and then select Start Scanning.
Note:
If you leave the printer untouched for the time set in Wait Time for Next Original aer you have been prompted to set
the next originals, the printer stops storing and starts sending the document.
Receiving Faxes on the Printer
If the printer is connected to the phone line and basic settings have been completed using the Fax Setting Wizard,
you can receive faxes.
You can save received faxes, check them on the printer screen, and print them as necessary.
Received faxes are printed in the printer's initial settings.
When you want to check the status of the fax settings, print a Fax Settings List by selecting Fax > (More) > Fax
Report > Fax Settings List.
Receiving Incoming Faxes
ere are two options in Receive Mode.
Related Information
& “Usage of Manual Mode” on page 112
& “Usage of Auto Mode” on page 113
Usage of Manual Mode
is
mode is mainly for making phone calls, but is also for faxing.
Faxing
>
Receiving Faxes on the Printer
>
Receiving Incoming Faxes
112
To Next Page
Loading...
Need help?
General
