Items Explanation
Geolocation
Latitude and Longitude (WGS84)
Enter the printer's location information. This entry is optional.
Enter values by using WGS-84 datum, which separates latitude and longitude with
a comma.
You can enter -90 to +90 for the latitude value, and -180 to +180 for the longitude
value. You can enter less than a decimal to the sixth place, and you can omit "+".
Top Priority Protocol Select top priority protocol from IPP and Port9100.
Wide-Area Bonjour Set whether or not to use Wide-Area Bonjour. If you use it, the printers must be
registered on the DNS server to be able to search the printer over the segment.
Require PIN Code when using IPP
printing
Select whether or not to require a PIN code when using IPP printing. If you select
Ye s , IPP print jobs without PIN codes are not saved in the printer.
Enable AirPrint IPP, Bonjour, AirPrint (Scan service) are enabled, and IPP is established only with
secure communication.
Conguring a Mail Server
Set the mail server from Web Cong.
Check below before setting up.
❏ e printer is connected to the network that can access the mail server.
❏ Email setting information of the computer that uses the same mail server as the printer.
Note:
❏ When you use the mail server on the Internet, conrm the setting information from the provider or website.
❏ You can also set the mail server from the printer’s control panel. Access as below.
Settings > General Settings > Network Settings > Advanced > Email Server > Server Settings
1.
Access Web Cong and select the Network tab > Email Server > Basic.
2.
Enter a value for each item.
3.
Select OK.
e settings you have selected are displayed.
When the setup completes, perform the connection check.
Related Information
& “Running Web Cong on a Web Browser” on page 271
Administrator Information
>
Settings to Use the Printer
>
Conguring a Mail Server
317
To Next Page
Loading...
Need help?
General
