ESAB Aristo U6 - Control Panel Working Method; Control Panel Components Overview

1 INTRODUCTION
0459 287 601
- 5 -
© ESAB AB 2020
- CONFIGURE MENU 1 / 1 -
LANGUAGE
DIMENSIONS
PANEL ENABLE
TRIGGER DATA
ENGLISH
METRIC
ON
OFF
↓ MAIN MENU NEXT
Press NEXT (i.e. the soft button on the right beneath the display) until the correct language is
shown in the display.
1.2 Control panel's working method
The control panel can be said to comprise two units: the primary memory and the welding
data memory.
1. Store 3. Welding data memory
2. Recall 4. Primary memory
In the primary memory, a complete set of welding data settings are created which can be
stored in the welding data memory.
When welding, it is always the content of the primary memory which controls the process. It
is therefore also possible to recall welding data settings from the welding data memory to the
primary memory.
Note that the primary memory always contains the most recently set welding data settings.
These can be recalled from the welding data memory or individually altered settings. In other
words, the primary memory is never empty or “reset”.
1.3 Control panel
1. Display
2. Knob for setting the voltage
3. Knob for setting the wire feed speed
and current
4. Soft keys, see further explanation
below
5. MENU button
Note! The functionality of all U6 control
panels are the same regardless of product
variant, i.e. even if the appearance is not
exactly like in the graphic to the left.