ESAB EMP235ic - Location and Lifting; Electrical Supply and Safety

4 INSTALLATION
0463 479 001
- 16 -
© ESAB AB 2017
4.1 Location
Position the power source so that its cooling air inlets and outlets are not obstructed.
A. 4in. (100 mm)
B. 4in. (100 mm)
4.2 Lifting instructions
The power source can be lifted using any of the handles.
Secure the equipment - particularly if the ground is
uneven or sloping.
4.3 Electrical supply
The supply voltage should be 230V AC ±10% or 120V ±10%. Too low supply voltage may
cause poor welding performance. Too high of welding supply voltage will cause components
to overheat and possibly fail. Contact the local electric utility for information about the type of
electrical service available, how proper connections should be made, and inspection
required.