Essilor E-Tess Tracer
3- Check Pro 1
6
- Port type used, choose by pressing repeatedly:
Serial port
Ethernet port
No PC
- Communication protocol, choose by pressing repeatedly:
OMA (serial port and Ethernet),
OMA+ (serial port only), used for the connection with Check Pro, (see Chapter 3),
PCCOM (serial port only), used for the connection with Opsys V1,
- Communication port configuration
:
Serial port:
Choose the baud rate (19200: usual rate)
Choose the flow control (Hardware control = usual configuration), None = Visual Lab
Pro configuration)
Validate your configuration .
Ethernet port:
Choose the mode type:
•
Static: usual mode,
•
Apipa: P to P operation,
•
DHCP: network operation.
Check the IP address, IP, if it does not correspond to your configuration:
•
Click on the "IP" zone, enter the required address on the numeric keypad,
•
Validate your entryor cancel your request .
Check the subnet mask, MSK, if it does not correspond to your configuration:
•
Click on the "MSK" zone, enter the required address on the numeric keypad,
•
Validate your entryor cancel your request.
To Next Page
Loading...