Essilor e-Tess - Self-Tests and Statistics

Essilor E-Tess Tracer
39 5- Automaintenance
11. After tracing, the screen displays:
12. Select the number of the standard gauge in the selection list,
13. Position your corresponding frame "standard gauge" in the tracing chamber, stable on the four lower
studs, with the "V" open upwards (for positioning, see Chapter 5.1.),
14. Start the tracing cycle ,
15. After tracing, the clamps open,
16. During the calculation phase, the screen displays:
This operation may take about 10 minutes.
17. An audible signal indicates the end of the calculations,


 If calibration is OK, the screen displays:
Press and continue using your tracer.


 If an error occurred, a message indicates the error reference. Refer to Chapter 7 to find
out the error type.
4.3. SELF-TESTS
This function allows you to test the various tracer movements.
1. Press to access the configuration/maintenance menu,