EST Encon Evolution - 1.3 Warnings and Symbols

Gas Requirements
 Helium or Nitrogen 60-80 PSI (414-552kPa) 99.999% GC/MS grade purity; BTU/hr. = NA
(compressed gas used for pressurization only)
Voltage
 115/230 VAC (+/-10%) 50/60 Hz
Current
Model
115VAC 230VAC
Current(A) Current(A)
EnconEvolution 10 6.3
Battery:
 CR2032 battery contained on SBC (CPU) board
Installation Category
 II
Pollution Degree
 2
Major Options
 Sample Foam Sensor
 Heated Glassware Kit
 Touch Screen Monitor
1.3 Warnings and Symbols:
English
 Warnings in the manual or on the Encon Evolution to be observed during installation,
operation, service and/or repair of the instrument. EST Analytical will assume no
responsibility for customers failing to comply with the safety precautions stated.
 Use of the Encon Evolution for something other than the intended use of the instrument is
prohibited.
 The use of the Encon Evolution is for trained personnel only.
 Personnel operating the Encon Evolution should wear safety glasses, safety shoes and
gloves where appropriate.
 The Encon Evolution is not intended for use in a hazardous environment.
 Installation of the Encon Evolution requires that there is nothing blocking the vents of the
system.
 Installation of the Encon Evolution requires that the instrument be placed on a non-
flammable surface capable of handling the weight of the instrument.