ETAS MDA V8.5 - Adjusting Signals

ETAS 5 Instruments
To hide and unhide the cursor's tooltips
To hide or unhide the sample values of the cursor's tooltips in the graph, do the
following:
1.
Click or use the tab Instrument in the Properties window.
2. To hide the tooltips, select Hide Cursor's Values Tooltips.
3.
To unhide them again, click and select the respective
entry.
To copy the signal values at cursor's position
To copy the signal values from a specific point in time to the clipboard, do the fol-
lowing:
1. Show the cursor by selecting Show/Hide Cursors in the cursors'
drop-down menu .
2. Move the cursor to the position of interest.
3. Right-click on the desired signal in the signal list and select Copy
contents.
The content of the visible columns and columns header are copied
in the clipboard.
To change the number of decimals of the cursor's tooltips
The number of decimals of the cursor tooltip is defined by the number of decim-
als for the respective signal. For more information, see "To change the number
of decimals" on page80.
To send the cursor time to EHANDBOOK-NAVIGATOR
If MDA V8.5 is connected to EHANDBOOK-NAVIGATOR, the cursor time is auto-
matically sent to EHANDBOOK-NAVIGATOR each time you change the cursor’s
position. For more information on how to establish a connection to
EHANDBOOK-NAVIGATOR, see "Connecting MDA to EHANDBOOK-
NAVIGATOR" on page21.
5.2.8 Adjusting Signals
In the Style column, the type of each signal is shown.
icon for discrete signals
icon for continuous signals
icon for Boolean signals
icon for Event signals
You can perform the following actions:
MDA V8.5 - User Guide 92