ETAS MDA V8.5 - Using Axes

ETAS 5 Instruments
1. To merge signals to one strip, right-click the desired signals from
different strips.
2. Click Move to New Strip.
or
1. To move signals to separate strips, right-click the desired signals
from one strip or different strips.
2. Click Move to Individual Strip(s).
To delete a strip
1. Open the context menu of the strip that you want to delete.
2. Select Delete Strip.
Note that a strip is also deleted when the last signal of a strip is removed.
5.2.5 Using Axes
You can perform the following actions:
l "To assign signals using the selection wheel" below
l "To use common axes" on the next page
l "To use individual axes" on the next page
l "To scroll axes" on page86
l "To scroll the time axis" on page86
l "To zoom axes" on page86
l "To adjust the axis range or set a favorite axis range" on page86
l "To set the default behavior for signal-to-axis assignment" on page87
l "To delete axes" on page88
To assign signals using the selection wheel
To assign signals to an oscilloscope, you can use the selection wheel. It
appears when signals are assigned to an oscilloscope or moved within an oscil-
loscope via drag and drop.
1. Drag the signals into the analog graphical area of the oscilloscope
or to the desired position in the signal list. After a short delay the
selection wheel appears.
2. Within the selection wheel, drop the signals onto one of the
options:
MDA V8.5 - User Guide 84