ETAS 2 Configuration Creation
To cancel an export
1.
In the bottom right corner, click .
2. Click the red icon next to the running export.
A warning symbol is shown to indicate that the export was can-
celed.
To check the export status
1.
In the bottom right corner, click .
All individual exports are listed. The status is marked as follows:
Blue: The export is in progress.
Red: The export has failed.
Yellow: The export was canceled.
Green: The export is finished.
The export icon shows the overall status of the export progress.
2. If you want to reduce this list, you can remove entries for exports
that are not in progress. Right-click an export in the list and choose
one of the following:
Remove finished element to remove this specific export
Remove all finished elements to clear the complete list of fin-
ished exports.
To see the exported file in Windows Explorer
1. Right-click an export in the list.
2. Select the option Open File in Windows Explorer.
2.4 Defining Variable Name Display
As variable names can be very long, and thus hard to read, MDA V8.5 allows to
shorten them based on user-definable rules. A rule searches the variable name
for a user-defined separator or character sequence and removes either the
name part in front or behind it. Additionally, the application of the rules can be
restricted to a group of variables. The combination of the rules and the group of
variables is called "rule set". All defined rule sets are listed in the block Rule
Sequence. The individual rule sets are applied subsequently in the listed order. If
the display name of a variable is modified by a rule set, the variable is excluded
from all following rule sets. This means that per variable only one rule set will be
used.
Note
Per signal only one rule set is applied.
The rule set affects the Display Name only, but not the Name, Display Iden-
tifier, or Symbol Link as shown in the Variable Explorer or Information Window.
MDA V8.5 - User Guide 37
To Next Page
