ETC Gio @5 - Page 552

550 Eos Family Operations Manual
OSC Method Arguments Examples/Comments
/eos/fader/<index>/<fader index>/ full none /eos/fader/1/2/full
/eos/fader/<index>/<fader index>/
level
none /eos/fader/1/2/level
/eos/fader/<index>/<fader index>/
+%
none /eos/fader/1/2/+%
/eos/fader/<index>/<fader index>/-
%
none /eos/fader/1/2/-%
Fader Status Information – see Implicit OSC Output (on page558) for more information
/eos/out/fader/<index>/<fader>/name
String argument with fader
label for OSC fader
/eos/out/fader/1/1=
“S 1 Label”
Sub 1 with a label “Label”
/eos/out/fader/1/2=
“IP 1 Label”
IP 1 fader labeled “Label”
/eos/out/fader/<index>/<fader>/name
Floating point argument for
fader percent (0.0-1.0)
/eos/out/fader/1/1=0.75
/eos/out/fader/1/2=0.0
/eos/out/fader/<index>
String argument, descriptive
text for OSC fader bank at
index
/eos/fader/1=“1”
Key
Note: For a list of supported key names, see Eos OSCKeys (on page579).
OSC Method Arguments Examples/Comments
/eos/key/<name> number for button edge: 1.0=down, 0.0=up (optional)
/eos/key/select active=1.0 (press [Select Active] but- ton)
/eos/key/select active=0.0 (release [Select Active] but- ton)
/eos/key/go 0
(press & release [Go] button)
Note: For the slash key, use a backslash /eos/key/\
Address
OSC Method Arguments Examples/Comments
Selection
/eos/addr number for address to select /eos/addr=513
Set Levels(Parksaddresswhileon theOSC commandline)