398 Eos Family Operations Manual
About Snapshots
Snapshots are record targets that store the current state of the Eos control surface and external mon-
itor configuration. These can then be recalled to instantly reset the console and displays to the state
stored in the snapshot. You can choose which parts of the front panel and displays you wish to store
as a part of the snapshot.
When you record a snapshot, aspects of the Eos user-interface, based on user-preference, are
stored so that you can recall them in the future. This allows you to bring the console back to a
desired state quickly.
Snapshots can be used on RPUs or RVIs to change what is currently displayed on the external mon-
itors and how that information is displayed.
Snapshots contents are global. They can be stored and recalled on any control interface, other than
Net3 RFRs. When recorded, they store the relevant settings of the device initiating the record. When
recalled, they recall only the controls that are appropriate on the device the snapshot is recalled.
Note: Snapshots that store the faders do not include the active cue in a fader. They only
include pending cues and fader attributes.
Snapshots of just a single monitor can also be recorded. See SingleMonitor Snapshots (on page50)
for more information.
Recording Snapshots
To store the current state of the console, record a snapshot.
[Record] [Snapshot] [1] On Element 2, you will need to use the {Snapshot} softkey.
When recording a snapshot, you will see a preview of all of the displays as they will be recorded in
the snapshot. You can choose to select/ deselect various components, monitors, frames, etc from
your snapshot.
To Next Page
Loading...
Need help?
General
