Cue Playback 363
Manual intensity override is not possible if there is any manual timing in the cue, as the fader is
already occupied with that control.
Manual Override
Manual override allows the associated fader to control all parameters in a transition state on
that fader. When [Fader Control] {Man Override} & [Load] are pressed, all activity on that
fader is frozen and the motorized faders move to match the current fade progression.
The fader is used to manually complete the cue transition for all parameters. If the fader is
operating in a paired mode, the left fader controls the intensity upfade and all non-intensity
parameters, while the right fader controls all intensity downfade actions. Manual control
override automatically releases when the cue is complete.
A group of faders can be collected for manual override by pressing [Fader Control] {Man
Override} & [Load] (continue adding faders by pressing the associated [Load] buttons).
Releasing Content From a Fader
There are a few ways to release content from a playback fader:
{Off} & [Load] - returns control to the background fader, either a cue or a submaster,
and stops any effects that are running on that fader. If there is no background value, the
intensities will just fade out. Press [Fader Control] to see {Off}.
Note:
Associated pending and current cues will remain when using {Off} & [Load].
Note:
Pressing [Go] will run the cues in their current sequence.
{Release} & [Load] - behaves like {Off} & [Load] except that it sets the pending cue to the
first cue in the list and removes the active cue. Press [Fader Control] to see {Release}.
[Shift] & [Load] - behaves like Release & [Load] except that it additionally removes the
content entirely from the fader. Pressing [Shift] & [Load] on an empty playback fader will
unmap the fader.
[Escape] & [Load] - unmaps all instances of the target (cue list, submaster, palette, or
preset) on a selected fader.
The [Go To Cue] [Out] [Enter]command can be used to fade out all intensities, reset all cue
lists to the top, and to clear out all background LTP fader values.
To Next Page
