ETC Ion Classic - Page 81

Console Overview 67
Ion Classic Components
Power Button
The power button on the front of the console is used to power up or power down. A separate
hard power switch, located on the rear panel, can be used to disconnect power from the
console’s internal components.
CAUTION: It is recommended that you safely power down the console via
Displays > Power Off Device, before disconnecting power from the console.
CAUTION: Power cord must be connected using an earth ground
connection.
WARNING: Before servicing your console, you must switch off the power
on the rear panel and disconnect the power cord completely.
External Monitors
Windows 7 Ion Classic can support up to 2 monitors, either 2 DVImonitors or 1 Display Port
and 1 DVI.
Display Port can use an active adapter to VGA, DVI, or HDMI. DVI-I can be converted to VGA
with a passive adapter.
Note: Output to 4K resolution monitors may affect console performance. ETC
recommends an external monitor resolution of 1024 or lower.
For monitor configuration, see {Monitor Arrangement...} (on page550) .