A pre-washing operation is highly advisable when using the machine for particularly dirty surfaces, as to allow the
chemical product present in the detergent solution to remove the dirt more efficiently.
Once pre-washing is over, clean the surface by activating the brush function. Do not use the squeegee to gather the
solution. During this operation it is advisable to lift the machine splashguard as to allow the detergent solution to spread
smoothly over the surface.
After a few minutes, wash the surface one more time after lowering the splashguard and activating the vacuum function as
to dry the floor.
To lift the splashguard (right & left), please refer to the following instructions:
Rotate the lever (pos 1) upwards.
Lift the splashguard (pos.2) manually by pulling it upwards;
Insert the lever (pos 1) into the hole (pos 3). In this way, the splashguard will remain raised from the ground.
Once pre-washing is over, release the lever (pos 1) from the hole, thus letting the splashguard pos. 2 lower and bending
the lever.
To Next Page
Loading...
