CLEANING THE SOLUTION PIPE FITTING
1
2
3
4
CHEMICAL
1.5%
2%
3%
4%
1%
ON/OFF
5
The machine is fitted with a metering pump for clean water and a metering pump for detergent.
If the solution does not flow out of the tank properly, make sure the output pipe fitting is not obstructed or clogged
(pos.1and 2).
POS.1: detergent output pipe fitting;
POS.2: clean water output pipe fitting.
To check that proceed as follows:
Bring the machine into a stop position in a flat surface area and put on the brake;
Lower the brush plate by pressing the special button in the control board;
With the lowered plate, turn off the machine and remove the key;
Press the emergency button (pos.5) so as to interrupt supply.
Unscrew the cap manually pos.3 OR POS. 4;
Use a thin piece of wire of approximately Ø2-3 mm and remove any incrustations from the pipe fitting pos.1 or pos.2;
Mount the cap;
Pull the emergency button upwards;
Insert the key and turn it towards the ignition
After some seconds, the machine will lift automatically the plate and it will be ready to start working.
To Next Page
Loading...
