Our scrubber-dryers must be operated by properly trained authorised staff.
Scrubber-dryers that do not operate properly must be taken out of service immediately.
Make sure to check the following before using the machine:
Make sure the battery connector is plugged-in;
Make sure the key is fitted correctly;
Check the battery charge level.
The charge level of the battery will appear in the
instrument panel when the machine is on. Charge the
batteries if the battery charging level is low
Make sure the brushes are in good condition and
mounted correctly.
Make sure the splash guards that are mounted into the
brush plate are in good condition
Make sure the rubber wheels on the squeegee are in
good condition and set properly
Release the parking brake using the lever;
Turn the key to position 1
Push the ON/OFF button. A green led will turn on and all the functions will be activated. At this
point, both the brush tray and the squeegee will lower. The brush motors and the vacuum motor
will switch by pressing the advance pedal. The quantity of detergent solution will be the one
which has been kept in memory since the last time the machine has been used. In case you wish
to adjust it, work on the + and – buttons -on the control panel.
The brush function can be enabled individually using this button on the instrument panel. The
brush plate will lower onto the floor by means of the actuator; however, the brushes will not start
rotating until the drive command is activated.
Press the button again to disable the function and the pilot light will start flashing giving enough
time to lift the brush plate and switch off the motors before turning off itself.
If during the washing operation, there is an over-absorption of the brushes, the cut-out switch
intervenes and stops the brushes. By pressing the advance pedal, the brush bottom starts flashing,
the writing E1 appears on the control board and after 5 sec. the plate will lift. To start again: turn
the key in pos 0 and then in pos. 1; activate the cut-out switch again.
It is possible to turn on the suction fan using the special button in the instrumental panel.
The squeegee will lower by means of the actuator; however, the suction fan will only come on
when the drive pedal is pressed. Press the button again to disable the function and the pilot light
will start flashing; the squeegee will remain on the floor for a preset period of time and it will
then lift and switch off the suction fan as well as the pilot light on the instrument panel.
The pilot light will also start to flash if the machine goes in reverse drive to indicate that the
squeegee is being raised from the floor. The machine is also fitted with a float that shuts off the
vacuum motor when the water level in the recovery tank is too high. If this occurs, the pilot light
on the suction motor button will start to flash and switch off the suction fan. The pilot light will
continue to flash until the tank is emptied, or until the machine switches off.
Drain the tank into the special drainage areas.
To Next Page
Loading...
