Check the condition of the brushes and replaced them if they are worn out;
Check the wear of the brushes: the minimum diameter shall not be less than 115 millimeters;
Check that there are not any wires, plastic threads or any other material which are tangled with the brush
Every 40 – 50 hours make sure to switch the front brush with the rear brush to even out the wear so they can last longer
CLEANING THE DETERGENT SOLUTION FILTER
The machine is fitted with a filter on the pipe that comes from the detergent solution tank.
In theory, the solution located in this tank should not have any impurities as the buckets or containers used to fill the solution are
supposed to be clean, in addition there is a filter in the mouth of the tank that filters the water
Follow the instructions below to clean the filter
Bring the machine into a stop position in a flat surface area and put on the
brake;
Turn off the machine and remove the key;
Close the valve pos.1;
Remove the transparent cup pos.2
Remove the protective screen (pos 3) and clean it with water together with the cup;
Put the cup (see position 2) and the protective screen (see position 3) on the fixed part of the filter (see position 4); make sure the
protective screen is fitted correctly into its housing inside the cup and into the support;
Open the valve pos.1.
To Next Page
Loading...
