Eureka E75/2 - Detergent Tank Filling; Solution Flow Adjustment

22
FILLING THE DETERGENT SOLUTION TANK
The tank should be filled using clean water mixed with appropriate detergent solution suited for the type of floor and
based on the condition of the floor. A product suitable for cutting down excess foam should also be used.
1
2
3
• Go to the rear part of the machine;
• Unscrew the cap (pos. 1);
• Pour the detergent directly from the canister (pos. 2) into the tank. Consult the package for information about the
percentage of detergent to use, the mixing procedures and safety measures to keep in mind.
Use low-foaming liquid detergents or a suitable product to cut down foam.
• After pouring the detergent solution, use a rubber hose (pos. 3) connected to the water supply system to fill the t.
The water used to fill the tank must not exceed 40°C.
WARNING: DO NOT POUR FLAMMABLE LIQUIDS INTO THE TANK.
• Once the tank is full, screw the cap back on (pos. 1).
ADJUSTING THE SOLUTION QUANTITY
ON THE BRUSHES (WATER + DETERGENT)
1
OFF
ON
The solution quantity on the brushes can be adjusted using
the lever (pos. 1).
While in up position, the lever will shut off the flow of the
solution completely.
Push down the lever gradually so that the valve can open
and increase the flow of the solution progressively.
Adjust the flow according to the operating speed and the
dirt conditions of the floor.
A solenoid valve keeps the solution from spilling out when
the machine comes into a stop position.