Eureka E75/2 - Using the Machine; Pre-Use Checks; Machine Operation Steps

25
USING THE MACHINE
Our scrubber-dryers must be operated by authorised staff who have been properly trained.
Scrubber-dryers that do not operate properly must be taken out of service immediately.
CHECK BEFORE USE
Make sure to check the following before using the machine:
• Make sure the battery connector is plugged-in;
• Make sure the key is inserted correctly;
• Check the battery charge level.
The charge indicator located in the instrument panel
displays the charging level of the batteries. Make sure
to charge the batteries when the battery charging level
is low.
• Make sure the brushes or discs are in good condition
and mounted correctly;
• Make sure the splash guard mounted on the brush plate
is in good condition;
• Check the integrity of the rubbers of the squeegee and
ensure they are set properly.
OPERATION
• Turn the key to position 1;
WARNING: After turning off the machine by the key, wait until 3 -4 seconds before
starting it again
• Lower the brush plate and push the brush switch to position 1.
The brushes will start spinning only when the machine starts moving forward;
• Lower the squeegee and push the vacuum switch to position 1.
The vacuum will start immediately.
The machine is also fitted with a float that shuts off the vacuum motor when the water level in
the recovery tank is too high;
• Use the provided lever to set the desired solution quantity.
Before starting the washing operation, check the quantity of solution present in the tank using the
gauge located in the rear part of the machine.
Fill the tank if the quantity is low;
• When starting the washing operation, make sure to lubricate the edge of the splash guard blades.
As soon as the brush plate lowers with the detergent solution opened, slowly move the machine back and forth
for 1 metre in order to get the splash guard rubber wet. This operation will protect the edge of the splash guard
blades and increase their durability;
• To avoid damaging the floor, be very careful not to stop the machine over the same area while the brushes
continue to spin;
• When the operator stops the machine, the brushes will stop spinning automatically 2 seconds after the drive pedal is
released. The flow of the solution will shut off when closing the solenoid valve. When resuming the drive operation,
the brushes will restart spinning and the solution will restart to flow automatically;
• If the squeegee leaves wet streaks on the floor during the washing operation, it means that there are pieces trapped
beneath the rear rubber of the squeegee. Lift the squeegee and remove the trapped pieces. Use a cloth to wipe off the
rear rubber if the pieces cannot be removed. In any case, it is always advisable to sweep the floors before washing;
• Before washing floors particularly filthy it is advisable to pre-wash the floors according to the instructions provided
above;
• At the end of each washing operation, lift the brush plate and the brushes will stop spinning, shutting off the solenoid
valve automatically every time the brush plate is lifted. Disengage the function by pushing the brush button to
position 0.
After lifting the brush plate, proceed for several metres with the squeegee lowered to finish the drying operation. Lift
the squeegee using the provided lever and wait for several seconds before turning off the vacuum using the switch,
this will prevent water droplets from falling into the floor.
• The working speed can be selected by pressing the slow / fast button: choosing the hare side, the
machine works at normal speed; choosing the turtle side the forward and reverse speed is reduced
of a 50%;