DRAINING AND CLEANING THE SOLUTION TANK
After completing the washing operation, in order to drain any leftover water from the solution tank and clean the tank,
proceed as follows:
• Lift the brush plate and turn off the switch on the control panel;
• Lift the squeegee and turn off the switch on the control panel after 10 seconds;
• Go to the provided area to drain the tank;
• Turn off the machine and remove the key;
• Remove the drain pipe (pos. 4) from the clean water tank and while keeping the pipe vertically, remove the cap (pos.
5) by turning it counter clockwise as indicated by the arrow. Part of the pipe is flexible (pos. 3), allowing it to be
squeezed to limit the water flow. Once the pipe is open, place it on the ground slowly;
• Remove the filling cap (pos. 2) and wash the tank using a rubber hose. Try to direct the water flow towards the front
part of the machine so as to clean it thoroughly;
• Once the washing operation is completed, close the cap (pos. 2) and put the drain pipe (pos. 4) back with the cap (pos.
5) screwed into place.
CHECKING BRUSHES OR ABRASIVE DISCS
After using the machine, remove the brushes or discs following the instructions described above.
• Check the integrity of the brushes and replace them if worn (the length of the lower bristle should be 10 millimetres);
• Check the integrity of the abrasive discs and replace them if worn.
To Next Page
Loading...
