The machine is fitted with a stainless-steel mesh filter used to protect the vacuum motor.
Weekly, or even daily for certain spaces, we suggest to check if filter is clean and if there is material that can block
the aspiration
Follow the instructions below to clean the filter:
• Stop the machine in a flat area;
• Turn off all the functions and remove the key;
• Move the container of the battery charger pos. 3, if present, above the cover of the recovery tank;
• Unscrew and remove the cap (pos. 1);
• Clean the screen without removing it (pos. 2);
• Put the cap (pos. 1) back on and make sure to tighten it correctly.
If the cap is not tightened properly, this may cause poor vacuum performance;
• Place again the container of the battery charger.
To Next Page
Loading...
