Eureka E75/2 - Scheduled Servicing Introduction; 100-Hour Service Checklist

40
SERVICING
For further informations regarding the servicing, consult the pages of the manual related
to maintenance
1°
SERVICING AND MAINTENANCE FOR SCHEDULED
SERVICING OF E65 - E75/2 - E83 - M650 - M750 - M830
AFTER 100 HOURS
DATE
DAY
MONTH
YEAR
WORKING HOURS
 Check that the battery clamps are not loosen or oxidized
 Check the batteries fluid level
 Check the cover gasket
 Check the vacuum motor filter
 Check the brake
 Check, and if necessary replace, the fuses
 Check the brushes and the components of the brush plate
 Check, and if necessary rotate or replace, the squeegee blades
 Check the adjusting/closing detergent solution tap
 Check the detergent solution filter (located just before the pump)
 Check the pump, the solenoid valve and the fitting outgoing from the pump
 Check that the vacuum pipe on the squeegee and the drainpipes of the solution and recovery tanks are
not broken or clogged
 Check the actuators of the squeegee and the brush plate (anyway if actuators have problems, they will be
detected by the control board)
 Lubricate the squeegee pivot pin
 Test the machine in all its operating functions
THE SCHEDULED SERVICING WAS CARRIED OUT BY:
NAME: _______________________________________________
SURNAME: ___________________________________________
SIGNATURE: __________________________________________
DISTRIBUTOR’S STAMP
NOTE: