Eureka E85 - MOUNTING ABRASIVE DISCS; ENGAGING AND RELEASING BRUSHES;DISCS

18
MOUNTING THE ABRASIVE DISC ONTO THE DISC PAD HOLDER
The machine can operate with brushes or abrasive discs of various types mounted on special disc pad holders.
Follow the instructions below to mount the abrasive disc onto the disc pad holder:
 Remove the disc lock (position 3) from the disc pad holder (position 1) by pressing the 2 ends of the spring catch
(position 4) against each other.
 Position the abrasive disc (position 2) and centre it onto the disc pad holder (position 1).
 Place the disc lock (position 3) on the centre and press down hard until the spring fits into place (position 4); this
operation can be carried out using the palm of your hand, or your foot if the disc pad holder is resting on the ground.
ENGAGING AND RELEASING THE BRUSHES OR THE ABRASIVE
DISCS
1
2
3
4
6
7
8
9
Follow the instructions below to engage the brushes or
disc pad holder with abrasive disc:
 Turn off the machine and press the key into position
0
 Position the brushes or the discs (pos. 2) under the
brush plate (pos. 1) lifting the splashguard (pos. 3).
While carrying out this operation, try to centre the
hole of the brush with the brush holder hub below
the plate.
 Turn the key (pos.8) into pos. 1 and wait till the
ignition sequenze is over and the battery charge
level is visibile on the display
 Lower the brush plate (pos. 1) by pressing the brush
button on the control panel (pos.6)
 Slowly push forward the drive control (pos.4). The
brush motors will start rotating and the machine will
start to move slowly. Go forward for a brief
distance and then go in reverse drive using the
switch (position 8) and step back slowly until
engaging the brushes. Repeat the operation if
necessary. To prevent leaked waste during the
operation, it is advisable to set the detergent
solution flow to 0 (all led lights in position 7 are
off).
Follow the instrcution below to release the brushes or
disc pad holder with abrasive disc:
 Lift the brush plate and press the brush button to
deactivate the brush function pos.6.
 Press the brush release button on the keyboard pos.
5. The releasing sequence will be activated and the
brush will be released from the plate.