Eureka E85 - FILLING THE DETERGENT SOLUTION TANK; DETERGENT TANK FILLING PROCEDURES

19
FILLING THE DETERGENT SOLUTION TANK
The tank should be filled using clean water mixed with an appropriate detergent solution suited for the type of floor and
for the dirty conditions of the floor and using a product suitable for cutting down foam.
 Go to the rear part of the machine;
 Unscrew the cap (position 2);
 Remove the device to facilitate filling (position 1).
 Carefully turn the device (position 1) towards the
direction indicated by the arrow;
 Place the device (position 1) once again into the
feed opening until it gets stuck in it in an inclined
position.
 Pour the detergent solution into the tank directly
from the can (position 2) using the filling device
(position 1). Look at the instructions on the
package to determine how much detergent
solution to use, how to mix the solution and what
safety precautions to take before using the
product. Make sure to use low-foaming liquid
detergents or appropriate products to cut-down
foam.
 After pouring the detergent solution, use a rubber
hose connected to the water supply system to fill
the tank. Make use the water used to fill the tank
does not exceed 40°C.
WARNING: DO NOT POUR
INFLAMMABLE LIQUIDS INTO THE
TANK
 After filling the tank, place the device (position 1)
once again into the tank and screw the cap back on
(position 4).