DRAINING AND CLEANING THE RECOVERY TANK
The recovery tank must be drained and cleaned after each washing operation.
In order to drain and wash the tank proceed as follows:
Turn off the washing function using the ON/OFF button and go to the tank drainage area ;
Turn off the machine, remove the key and put on the brake.
Open the hood of the seat pos. 1 by releasing the special safety hook;
Open the tank lid pos. 2 by lifting it manually till the safety bar pos. 8 gets inserted;
Remove the safety filter for bigger debris (pos. 4) by holding it from its upper part and pulling it out of the tank.
Empty the filter in an appropriate dirt container. To carry out this operation, bend the sealing rubber pos. 3.
Wash the filter with water and remove the pieces which have got stuck through the meshes of the net, if there are any.
Remove the drain pipe from the dirty water tank (see position 6) and while keeping the pipe vertically (see position 5)
open the lid by rotating it counterclockwise as indicated by the arrow. Part of the pipe is flexible (see position 7) and
therefore it can be squeezed to limit the water flow. Once opened, lay the pipe on the ground.
After draining the tank, make sure to clean it thoroughly using water
Wash the ECO-SYSTEM fiter (pos.9) use water throughout the filter, paying attention not to damage it.
After each working day, carefully remove the filter and wash it inside in order to remove possibile encrustations.
Before doing it, wash the area surrounding the filter. Unscrew the filter anti-clockwise.
Do not remove the safety filter pos.10 placed on the connection in which the filter is screwed in. To clean it, wash it
with water.
Wash the level sensors pos.12. Do not direct the water flow directly onto the sensors as not to damage them. If
necessary, clean them by using a tissue in order to remove the material which might have got stuck in them (metallic
debris) and could thus prevent the floating device from closing properly.
After completing the cleaning procedures, remount the ECO-SYSTEM filter (pos.9), put the cap back on the dirty
water drain pipe and rotate it clockwise, then place the pipe back into its housing in the tank.
The suction pipe on the squeegee (pos. 11) shall be washed periodically, in order to prevent encrustation formation
inside the pipe. AVOID SPLASHING WATER ONTO THE BATTERY TRAY WHILE CLEANING
THE TANK.
To Next Page
Loading...
