The max. quantity of the solution on the brushes can be adjusted by using the + and – keys (pos. 2) located on the board
panel.
Our scrubber-dryer features a solution electronic dosing system which – for being proportional to the machine speed-
constantly allows for the correct flow of solution on the brush – thus minimizing any waste. In fact, by decreasing the
machine speed, the solution flow decreases accordingly. On the contrary, by increasing the machine speed, the flow will
increase till reaching the preset maximum level at maximum speed.
The above-mentioned dosing device can be activated also with the machine in ECO-SYSTEM mode.
Make sure that the valve (pos. 1) located beneath the machine is open before operating the machine.
A pre-washing operation is highly advisable when using the machine for particularly dirty surfaces, as to allow the
chemical product present in the detergent solution to remove the dirt more efficiently.
Once pre-washing is over, clean the surface by activating the brush function. Do not use the squeegee to gather the
solution. During this operation it is advisable to lift the machine splashguard as to allow the detergent solution to spread
smoothly over the surface.
After a few minutes, wash the surface one more time after lowering the splashguard and activating the vacuum function as
to dry the floor.
To lift the splashguard, please refer to the following instructions:
Lift the splashguard (pos. 1) manually by pulling it upwards;
Make the 3 blocking lever pos. 2 rotate. This way, the splushguard will remain raised from the ground.
Once pre-washing is over, unfasten the screws pos. 2 thus letting the splashguard pos. 1 lower.
To Next Page
Loading...
