Evco c-pro 3 OEM - Page 12

EVCO | 06.08.2021 | AZ | 12114CP3OEE104
c-pro 3 OEM - Hardware manual
Connector 7
Number Description
USB USB port, for device programming
Connector 8
Number Description
AO4 Analogue output 4 (for 0-10 V or PWM)
AO3 Analogue output 3 (for 0-10 V or PWM)
AO2 Analogue output 2 (for 0-10 V or PWM)
AO1 Analogue output 1 (for 0-10 V or PWM)
M9
Digital input
(dry contact and for pulse trains up to 2 KHz) DI4
M8
Digital input
(dry contact and for pulse trains up to 2 KHz) DI3
M7
Analogue input
(for PTC, NTC or Pt 1000 probes) AI7
can be congured also for dry contact digital input
DI12
M6
Analogue input
(for PTC, NTC or Pt 1000 probes) AI6
can be congured also for dry contact digital input
DI11
M5
Analogue input
(for PTC, NTC or Pt 1000 probes) AI5
can be congured also for dry contact digital input;
DI10
M4
Analogue input
(for PTC, NTC or Pt 1000 probes) AI4
can be congured also for dry contact digital input
DI9
M3
Analogue input
(for NTC probes, 0-5 V, 0-10 V, 0-20 mA or 4-20 mA
transd.) AI3
can be congured also for dry contact digital input
DI8
M2
Analogue input
(for NTC probes, 0-5 V, 0-10 V, 0-20 mA or 4-20 mA
transd.) AI2
can be congured also for dry contact digital input
DI7
M1
Analogue input
(for NTC probes, 0-5 V, 0-10 V, 0-20 mA or 4-20 mA
transd.) AI1
can be congured also for dry contact digital input
DI6
GND Reference (GND)
12V Auxiliary power supply (12 VDC)
5V Ratiometric transducer power supply 0-5 V (5 VDC)
Connector 5
Number Description
PS Device power supply (115... 230 VAC)
PS Device power supply (115... 230 VAC)
Connector 6
Number Description
ITB INTRABUS port data
GND Reference (GND)
A+
If present, signal + RS-485 MODBUS master/slave
port
B-
If present, signal - RS-485 MODBUS master/slave
port
C+ Signal + CAN port
C- Signal - CAN port
Connector 9
Number Description
DIHV5 High voltage digital input; DI5
DIHV5 High voltage digital input; DI5
Connector 10
Number Description
IN Input Pulse digital outpuyt (230 VAC max. 30 W)
OUT Pulse digital output