Evco c-pro 3 Series User Manual

EVCO S.p.A. c-pro 3 | Hardware manual ver. 2.0 | Code 114CP3E204
page 51 of 86
Diagnostic Math parameter available in read only modality
Math status
ok = not in error
err = in error (because of overflow,
underflow, division by zero or
NaN)
Diagnostic Key Par parameter available in read only modality
result of the copy of the parameters from the
controller to the programming key EVKEY10
and vice versa
ok = operation successful
completed
err = operazione failed
Main time parameter available in read only modality
main cycle time of the application software
(in milliseconds)
Debug
[ Algo ]
Int. time parameter available in read only modality
interrupt cycle time of the application
software (in milliseconds)
rx parameter available in read only modality number of packages in transmission
Debug
[ CAN bus ]
tx parameter available in read only modality number of packages in reception
err parameter available in read only modality number of packages in error
Debug
[ CAN bus ]
ovf parameter available in read only modality number of packages in overflow
Debug 5VP parameter available in read only modality
reading the power supply voltage of the
ratiometric transducers
Debug 24VP parameter available in read only modality
reading the power supply voltage of the
0-20 mA / 4-20 mA / 0-10 V transducers
Stack parameter available in read only modality minimum free stack
Debug
Buf parameter available in read only modality number of free buffers
Notes:
(1) the submenu is visible on condition that the application software expects the RS-485 port is configured to support the Modbus
communication protocol.

Evco c-pro 3 Series Specifications

General

Brand	Evco
Model	c-pro 3 Series
Category	Controller
Language	English