Evco c-pro 3 Series User Manual

EVCO S.p.A. c-pro 3 | Hardware manual ver. 2.0 | Code 114CP3E204
page 62 of 86
6.4.3. List of configuration parameters of c-pro 3 EXP hecto and of
c-pro 3 EXP hecto+
Submenu Parameter Min. Max. Unit Preset Description
Info PROJ parameter available in read only modality
information about the application project
(project, version and revision)
Info FW parameter available in read only modality
information about the firmware (project,
version, revision and subrevision)
Info HW parameter available in read only modality
information about the hardware (version,
revision, generic (G) or special (S))
Info SW parameter available in read only modality
information about UNI-PRO 3 (version and
revision)
Info SN parameter available in read only modality
information about the serial number and the
result of the productive test
Info MASK parameter available in read only modality
information baout the mask (it depends on
the builder’s coding system)
Info date and time parameter available in read only modality
date and time of the last compilation of the
application project
Parameters (1) AI1 - - - - - - - - - NTC
kind of probe analog input 1
PTC = PTC probe
NTC = NTC probe
0-20mA = 0-20 mA transducer
4-20mA = 4-20 mA transducer
0-5V = 0-5 V ratiometric transducer
0-10V = 0-10 V ratiometric transducer
PT1000 = Pt 1000 probe
Parameters (1) AI2 - - - - - - - - - NTC
kind of probe analog input 2
PTC = PTC probe
NTC = NTC probe
0-20mA = 0-20 mA transducer
4-20mA = 4-20 mA transducer
0-5V = 0-5 V ratiometric transducer
0-10V = 0-10 V ratiometric transducer
PT1000 = Pt 1000 probe

Evco c-pro 3 Series Specifications

General

Brand	Evco
Model	c-pro 3 Series
Category	Controller
Language	English