2
Table of Contents
Safety Information ....................................2
Warranty ............................................3
Retain Original Purchase Receipt For Warranty Eligibility .....3
Two (2) Year Limited Warranty ..........................3
Pre-Installation .......................................4
Application .........................................4
Tools Required ......................................4
Package Contents ...................................4
Determine The Depth Of Your Well .......................5
Location Of The Pump ................................5
Tanks - Pre-Charged Storage ...........................5
Shallow Well Installation ...............................6
Materials Required (Not Included) .......................6
Replacing An Existing Pump ...........................7
New Shallow Well Installation
(Depth To Water 25 Ft. Or Less) .........................8
Pressure Switch Assembly .............................12
Deep Well Installation .................................13
Materials Required (Not Included) ......................13
Replacing An Existing Pump ..........................13
New Deep Well Installation (4 In. Or Larger Well) ...........14
Specifications .......................................20
Performance ......................................20
Winterization ....................................... 21
Safety Information
DANGER:
such as oil, gasoline, kerosene, ethanol, etc. Do not use
personal injury, and/or death.
DANGER: ALWAYS disconnect the power to the pump
before servicing.
DANGER: Do not touch the motor housing during
operation. The motor is designed to operate at high
temperatures. Do not disassemble the motor housing.
DANGER: Do not handle the pump or pump motor with
wet hands or when standing on a wet or damp surface, or
in water.
WARNING: Wear safety goggles at all times when
working with pumps.
WARNING: This is a dual voltage 115/230 V pump.
VOLTAGE SELECTOR INSIDE PRESET TO 230V.
For 115V selection, please open the terminal cover and
set the switch to the proper voltage. All wiring should be
WARNING: Protect the electrical cord from sharp objects,
hot surfaces, oil, and chemicals. Avoid kinking the cord.
Do not use damaged or worn cords.
WARNING: Failure to comply with the instruction and
designed operation of this unit may void the warranty.
ATTEMPTING TO USE A DAMAGED PUMP can result in
property damage, serious personal injury, and/or death.
WARNING: The pump should be connected to a
230V/115V GFCI outlet protected with a 15 amp (230V)/30
amp (115V) fuse or circuit breaker.
CAUTION: Know the pump and its applications,
limitations, and potential hazards.
CAUTION: Secure the pump to a solid base.
CAUTION: Periodically inspect the pump and system
components. Disconnect the pump from the power supply
before inspecting.
CAUTION: Follow all local and National Electrical Codes
(NEC), state and local building codes, and all Occupational
Safety and Health Administration (OSHA) guidelines.
IMPORTANT: The motor of this pump has a thermal
protector that will trip if the motor becomes too hot. The
protector will reset itself once the motor cools down and an
acceptable temperature has been reached. The pump may
start unexpectedly if it is plugged in.
IMPORTANT: Ensure the electrical power source is
adequate for the requirements of the pump.
IMPORTANT: This pump is made of high-strength,
corrosion-resistant materials. It will provide trouble-free
service for a long time when properly installed, maintained,
and used. However, inadequate electrical power to the
pump, dirt, or debris may cause the pump to fail. Please
carefully read the manual and follow the instructions
regarding common pump problems and remedies.
Wiring Connections ...................................11
Troubleshooting .....................................21
To Next Page
Loading...
