3. LOG
YES: Select YES if you wish to record Motion Events log in the HDD.
NO: Select NO if you do not wish to record Motion Events log in the HDD.
4. DURATION
The amount of time a motion event will record - from 1 sec to 99 seconds. The default
value is 5 seconds. To change this, simply use the Jog Dial on the DVR.
5. ALARM OUTPUT
This will transmit a signal to another device. The setting of alarms are NONE = not
activated, 1 = output signal 1 transmitted, 2 = output signal 2 transmitted, 3 =
output signal 3 transmitted and 4 = output signal 4 transmitted. To change this,
simply use the Jog Dial on the DVR. (Only EDVR16D3 model has 4 alarm outputs, all
the rest models have only 1 alarm output).
6. ALARM EMAIL
YES: Send an email when an alarm occurs.
NO: Do not send an email when an alarm occurs.
The email address and e-mail server can be set in the NETWORK SETUP MENU.
7. ALARM NETWORK
YES: Enable alarm network when an alarm occurs.
NO: Disable alarm network when an alarm occurs.
BUZZER: Audible buzzer when motion is detected.
ENABLE: To enable a motion buzzer.
DISABLE: To disable a motion buzzer.
8. MAIN MON: Display on a main monitor when an alarm occurs.
NO CHANGE: No change on the display in the main monitor when a motion occurs.
FULLSCREEN: A full screen of the active camera will display when motion occurs.
9. CALL MON: Display on a call monitor when motion occurs.
NO CHANGE: No change on the display in the main monitor when motion occurs.
ACTIVE CAMERA: Display the active camera that is set for Motion in full screen
mode to the call monitor. SUMMARY
33
To Next Page
Loading...
