70
Electrical System
Stereo Memory
Protects the circuit that supplies continuous 12
volt electrical current to the memory circuit in
the stereo.
Shower FLT
Protects the circuit for the automatic switch that
activates the shower sump pump located in bilge
below the cabin sole.
Aft 1 FLT
Protects the circuit for the automatic switch that
activates the mid stern bilge pump located in the
stern bilge. A red light in the Aft 2 Bilge Pump
switch will be lit whenever the pump is activated.
Aft 2 FLT
Protects the circuit for the automatic switch that
activates the stern bilge pump located in the bilge.
A red light in the Aft 1 Bilge Pump switch will be
lit whenever the pump is activated.
Alarm
Protects the circuit for the automatic oat switch
that activates the high water alarm. The high
water alarm will sound to alert the operator of
unusually high water in the bilge.
Gost
Security System
CO Monitor
Protects the circuit that supplies continuous 12
volt electrical current to the carbon monoxide
detector in the cabin.
The power indicator on the carbon monoxide de-
tector should be lit whenever someone is occupy-
ing the cabin. If the fuse has blown, it indicates
that there is a problem with the carbon monoxide
detector or the wiring from the fuse panel to the
detector. Always determine the cause of the
problem and correct it before replacing the fuse
or occupying the cabin.
Notice:
The continuous power circuit fuses are al-
ways supplied current when the batteries
are connected. These circuits are not deac-
tivated when the battery switches are off.
Continuous Power Fuse Panel
Typical Generator Fuse Panel
PROPER FUSE OR BREAKER PROTECTION MUST BE PROVIDED
FOR ALL 12 VOLT EQUIPMENT ADDED. DO NOT OVERLOAD THE
ACCESSORY CIRCUIT BREAKERS, FUSE PANELS OR OTHER
CIRCUITRY THROUGH ADDITIONAL 12 VOLT EQUIPMENT.
Generator Fuse Panel
A fuse panel is typically installed on the generator
near the controls to protect the DC circuits.
To Next Page
Loading...
