Need help?Do you have a question about the Evinrude E-TEC E150DPXSCF and is the answer not in the manual?
General| Power Output | 150 HP |
|---|---|
| Gear Ratio | 1.86:1 |
| Starting System | Electric |
| Cylinders | 6 |
| Full Throttle Operating Range | 5000-6000 RPM |
| Fuel Induction System | Direct Injection |
| Oil Injection | Yes |
| Displacement | 2592 cc |
| Fuel System | E-TEC Direct Injection |
| Cooling System | Thermostatic controlled |
| Steering | Remote |
| Shaft Length | 508 mm (20") |
| Emissions Compliance | CARB 3-Star |
| Weight | 445 lbs (202 kg) |
Provides key technical specifications for engine, fuel, electrical, cooling, and gearcase.
Covers procedures for rigging the outboard, including controls and batteries.
Details fuel requirements, priming procedures, and oiling system setup.
Provides instructions for mounting the outboard on the boat transom.
Covers procedures for mounting the outboard to the transom.
Details routing of cables, hoses, and wiring harnesses.
Covers tests for ignition system components and circuits.
Details tests for fuel system components like pumps and injectors.
Details tests for stator resistance and voltage output.
Explains testing procedures for the 12V and 55V charging circuits.
Provides a diagram and operation details for the electric start system.
Details testing procedures for the SystemCheck warning lights and horn.
Provides procedures for adjusting and verifying ignition timing.
Details procedures for starter removal, disassembly, and assembly.
Covers tests for fuel system pressure, injectors, pumps, and hoses.
Provides procedures for servicing fuel system components.
Covers EMM programming for oiling rates and break-in procedures.
Details tests for the oil injection pump and sending unit.
Provides procedures for servicing oil distribution hoses and injection pump.
Provides methods for checking engine operating temperature.
Details the steps for removing the powerhead from the outboard.
Covers general disassembly procedures for the powerhead.
Covers removal, inspection, and identification of rods and pistons.
Covers inspection of powerhead components like pistons, rings, and bearings.
Details procedures for assembling the powerhead components.
Provides instructions for installing the powerhead.
Covers propeller inspection and gearcase leak testing.
Provides guidance for diagnosing and resolving trim/tilt system issues.
Troubleshooting steps for when the outboard does not start.
Troubleshooting steps for when the outboard is difficult to start.
Troubleshooting steps for when the outboard does not shut off.
Troubleshooting steps for when the outboard starts and then stalls.
Troubleshooting steps for when the outboard surges or runs rough.
To Next Page
