Evinrude E-TEC E115DSLSCR User Manual

Defines DANGER, WARNING, and CAUTION signal words used for safety messages.

Details the process of physically mounting the outboard to the boat's transom.

Provides a schedule for routine inspections and maintenance tasks.

Procedures for servicing outboards that have been submerged.

Describes the function and behavior of internal sensors monitored by the EMM.

Details external sensors that provide data to the EMM.

Explains the meaning of EMM LED indicator lights for system status.

Covers using diagnostic software for troubleshooting and adjustments.

Outlines general procedures for diagnosing system issues.

Describes tests performed while the outboard is running to diagnose problems.

Procedures for testing ignition system components and circuits.

Methods for testing fuel system components and their delivery capabilities.

Procedures for testing various engine sensors.

Covers resistance and voltage output tests for the stator.

Procedures for testing the 12V and 55V charging systems.

Details the components and operation of the electric start system.

Procedures for testing the SystemCheck warning system and its components.

Procedures for adjusting and verifying ignition timing.

Covers removal, disassembly, cleaning, and installation of the electric starter.

Procedures for testing various aspects of the fuel system's performance.

Step-by-step instructions for servicing fuel system components.

Information on adjusting oil injection rates and break-in procedures.

Procedures for testing various aspects of the oiling system.

Step-by-step instructions for servicing oil system components.

Explains how the cooling system functions under different operating conditions.

Procedures for checking engine operating temperatures.

Step-by-step instructions for removing the powerhead from the outboard.

Procedures for disassembling the powerhead into its major sub-assemblies.

Guidelines for inspecting cleaned powerhead components for wear or damage.

Procedures for reassembling the powerhead after inspection or repair.

Steps for installing the assembled powerhead onto the outboard.

Step-by-step instructions for removing and installing the gearcase.

Detailed disassembly procedures for standard rotation gearcases.

Detailed disassembly procedures for counter-rotation gearcases.

Guides for diagnosing and resolving common trim/tilt system problems.

Detailed disassembly and assembly procedures for the three-piston trim/tilt system.

Detailed disassembly and assembly procedures for the single-piston trim/tilt system.

Troubleshooting guide for when the outboard fails to start.

Troubleshooting guide for difficult starting conditions.