213
OILING SYSTEM
OIL COMPONENT SERVICING
9
Install oil pump bracket and retaining screws.
Tighten small screw to a torque of 24 to 36 in. lbs.
(3 to 4 N·m) and longer screw to 96 to 120 in. lbs.
(11 to 13.5 N·m).
Position the oil injection pump assembly on
bracket and install Oetiker clamp.
Reconnect the electrical connector.
IMPORTANT: Use oil primer bulb to purge air
from oil supply hose before reconnecting hose to
oil pump.
Reconnect oil supply hose to the inlet fitting of oil
pump. Fasten with Oetiker clamp.
Make sure oiling system is primed. Check oil flow
through oil distribution hoses. Check oil system
operation and routing of oil hoses. Refer to Oil
Supply Priming on p. 54.
Run the outboard and check for leaks.
Repair any oil leaks and any kinked or misrouted
hoses.
1. Clamp 005346
1
1. Oil supply hose
2. Oetiker clamp
005346
2
1
To Next Page
Loading...
Need help?
General
