228
POWERHEAD
POWERHEAD REMOVAL
POWERHEAD REMOVAL
Remove lower motor covers. Lower Cover
Removal on p. 91.
Remove flywheel cover and rear shroud.
Remove air temperature sensor from air silencer.
Remove the air silencer.
Disconnect power trim connectors.
Remove screw and washer from shift rod lever to
release the lower shift rod.
WARNING
Protect against hazardous fuel spray.
Before starting any fuel system service,
carefully relieve fuel system pressure.
Refer to Relieving Fuel System Pressure
on p. 183.
To prevent accidental starting while ser-
vicing, disconnect the battery cables at
the battery.
005248
005272
1. Tilt limit switch connector
2. Sending unit connector
005254
1. Tilt relay connector 005255
1. Shift rod screw 005253
2
1
1
1
To Next Page
Loading...
Need help?
General
